| Products Shipped Australia Wide with TNT and TOLL. Track your Order. |
"Unbelievable service from Red Baron. Less than 24 hours and we've got our new P300 pool pump. And the price, $240 less than our local pool shop. The advice about the replacement pump was a great improvement on the local pool shop too, that tried to sell us inferior product for a higher price.
Guys, do your research 1st then ring Red Baron for a great price and good old fashioned service! Thanks Red Baron, P300 is humming away ever so silently (compared to our old one!!) We'll just have to wait and see the next electricity bill if P300 delivers savings as indicated in the reviews and we'll be even happier. Melissa-Sydney" READ MORE |
|
A brominated system contains inactive bromide salts. These bromide ions are reactivated by oxidisers to create active hypobromous acid. These bromide . . . read more
A brominated system contains inactive bromide salts. These bromide ions are reactivated by oxidisers to create active hypobromous acid. These bromide . . . read more
Bromination is similar to chlorination, but there are some major differences. Hypobromous acid cannot be stabilised, and in high levels, stabiliser ca . . . read more
It is not necessary to perform any special conversion steps. Follow the manufacturer's instructions for setting up your salt chlorinator. . . . read more
Bromination is similar to chlorination, but there are some major differences. Hypobromous acid cannot be stabilized, and at higher residuals, stabilis . . . read more
There is very little that needs to be done to switch from salt chlorination to another chlorinating product. Follow instructions for disconnecting the . . . read more
The following products are NOT COMPATIBLE with biguanide-based products: ALL Chlorine and Bromine products including tablets, granules and sticks, Bio . . . read more
There are three methods to choose from for converting from SoftSwim®, Baquacil® or other biguanide systems to chlorinating or brominating products. . . . read more
Shut off the pump. Pre-dissolve 1.2 kg of Burn Out 35 per 10,000 litres in at least 20 litres of water. Dissolve at a rate of 300 grams per 5 litres. . . . read more
NOTE: Shocking the pool each day with Burn Out 35 for approximately one week may be necessary to eliminate all chlorine demand and clear the water. . . . read more
CAUTION: DO NOT DRAIN without consulting your dealer, manufacturer or builder. Due to environmental factors, such as high water tables, structural pro . . . read more
Remove the ionisation unit from the pool. Test the copper residual. Add Scale Inhibitor according to label instructions. (Scale Inhibitor is being app . . . read more
Remove the ionisation unit according to manufacturer or dealer instructions. Test the water for copper and apply Pool Magnet according to label instru . . . read more |
|
